small creaturesa field guide to the insects and spiders in NZ homes and gardens

Active or old borer? Reading the signs

entry no. 01 · 2026-11-20

Finding a scatter of small round holes in a floor joist or a wardrobe does not tell you whether borer is still at work. The holes are a record of beetles that have already left. Some wood has been quiet for decades, while other timber can hold a working population of larvae with only a few holes to show for it. Reading the signs correctly depends on understanding how the beetle's life runs, because the clues are tied to the calendar.

Why the holes are a delayed record

The common house borer (Anobium punctatum) spends most of its life hidden. According to Scion's species account, republished by the NZ Farm Forestry Association, the egg to adult cycle takes about three years in kahikatea sapwood and four years in rimu and radiata pine, depending on temperature, moisture and the nutrition of the wood. For that whole period the larvae tunnel through the sapwood without leaving any opening to the surface.

The visible event comes at the end. Pupation happens in a chamber just below the wood surface, and the adult beetles then chew a round exit hole about 1 to 2 mm across. Emergence is concentrated between November and January, and the adults live roughly four weeks without feeding. So every hole marks a beetle that is gone, and a hole on its own says nothing about the larvae still inside.

The season matters

BRANZ's Renovate bungalows guide gives a practical rule: fresh holes and dust that appear between November and March indicate that the infestation is still active. This is the main evidence of a working infestation, because it shows beetles are emerging now, and the next generation may already be developing in the same timber. The same guide notes that both common borer and longhorn borer lay their eggs on a rough timber surface or in cracks or holes, and that the larvae bore into the timber, sometimes for up to three years.

That timing explains why an inspection in July can look cleaner than one in January. Evidence of activity is easier to see in season. If you suspect activity and have time to wait, noting the state of a surface in spring and checking it again in summer is more informative than a single winter look.

Bore dust: what fresh looks like

The dust beneath the holes, called frass, is the second clue. Scion describes borer frass as loosely packed and granular, gritty when rubbed between the fingers, and it can dribble from the exit holes when dislodged by emerging beetles, by parasites or by vibration. Seeing dust fall from a hole, or finding a small clean pile freshly accumulated beneath a cluster of holes, points to recent activity.

A simple check follows from the calendar. Wipe or vacuum the dust from a suspect area in winter, mark or photograph it, then look again after the summer emergence period. New dust or new holes in that spot mean borer was active that season, in line with BRANZ's guidance on fresh holes and dust. Nothing new suggests the timber there is quiet, at least for now. Dust that has simply sat for years, with no change over a full season, does not count as evidence of a live infestation.

Other clues in the wood

A few other observations add context:

What the holes might not be

Check you are not looking at a different insect. The larger oval holes of the two-tooth longhorn borer, which BRANZ says can be up to 5 mm long, are a separate problem. The NZ Farm Forestry Association also notes that the pine bark anobiid makes holes of about 2 mm that are often mistaken for house borer holes, and its larvae look very similar to the house borer's. If a hole is oversized or oval, or the timber is pine bark rather than structural sapwood, the evidence may not mean borer in the house sense at all.

How serious is it?

BRANZ points out that infestation by the common house borer tends to stop before timber becomes structurally unsound, because the beetle attacks sapwood only and most framing has enough heartwood to avoid serious weakening. Scion adds that mild infestations are mainly superficial but can mar finished surfaces, while repeated reinfestation can cause timber to fail. Context is everything: a few holes in a weatherboard are cosmetic, whereas active damage in a primary support member in a damp subfloor deserves a professional opinion.

Scion lists replacement with preservative-treated timber as the most satisfactory remedy, and notes that fumigation requires a licensed operator and that reinfestation can follow. If you are weighing options for infested framing or flooring, it is worth reading what is involved in professional borer treatment, which typically starts with confirming activity and the extent of the damage.

Getting a second opinion

Evidence such as photographs of fresh dust taken in season, the size of the holes, and the moisture of the timber all help an assessor reach a view. A firm such as Lignum Timber Inspections can look at the timber in person and advise whether the borer is active or historic, which is better than relying on a single photo of a hole.

Sources

next entry → Wētā in the house: which species it is and what to do